ArmorSuit 2 Pack for Samsung Galaxy S24 Ultra Paper-Feel Texture Screen Protector (6.8") Case Friendly MilitaryShield Matte Film - Made in USA

I should have bought this screen protector for my S8+ in the first place. I have a Blackberry PRIV with a curve screen and I installed an ArmorSuit matt protector. When I got my S8+, I tried a glass screen protector instead. I had gone through 4 of them. The first two was of different brands and both only had adhesive along the edges. These are easy to install and provide a bubble and air gap free viewing area. The issue is that these do not stay on the screen reliably. My first one popped out and cracked when I dropped my phone. My S8+ was not damaged as it had a case and the screen was also fine. As long as my phone screen is protected while the protector is cracked, I do not mind as protector is cheap.So, I went ahead and try another similar one from another manufacturer. The second one lasted longer but it did not stay glued on the screen after a few months. So, I use a little contact cement on the edges and continue to use it. The protector popped a few weeks ago while I was changing phone cases. I could have use contact cement fix again but I notice that the protector is a bit scratched up. That means that these glass protectors are not as hard as they claimed.I order a package of two glass protectors with full adhesive this time. That was a mistake. I spent 2 weeks trying to install the protectors and cracked them both. The problem is that the one I bought does not fit the screen. It looked like it fit but it did not. I could not get the curve edges down. There is no way I could press the edges down long enough to get them glue down. I even put rubber bands on to get the edges down. I placed the phone under a stack of books overnight also. Every day, I remove the rubber bands and the edges were still popping up. However, this condition improved and I managed to get rid of all the air gaps and bubbles other than one corner. I reduced the rubber bands and only placed them where the pressures were needed. I cracked both protectors while working on moving the bubbles out to the edges.I was unable to use my S8+ for 2 weeks, luckily this is my spare phone as I switched to a LG G7. I had no issue in installing a glass protector on the G7 but this S8+ was a nightmare.Quite a few of my phones and tablets have ArmorSuit protectors so, I ordered one. I thought I would be saving time by using a glass protector but no. Compare to the full adhesive curve screen proctor, this film protector is time saving.What was not expected is that there is may be 3 tiny air bubbles on the display even though I cleaned and cleaned the phone before installation. Since the protector was only installed a day ago, these tiny air bubbles might go away in a few more days. These bubbles are quite small and they are small enough that I could not take a good picture of showing them. The important thing is all the edges are glued down.If you have a phone with a curve screen, I would definitely recommend using this ArmorSuit product. All of my phones and tablets that have this film protectors are still on without any issue.

I am a big fan of ArmorSuit and their screen protector product line. This is the only brand of screen protector I have used for the past 7 years on my Android devices and I continue to re-order from them each time I upgrade to a new phone. I don't really have another brand to compare them against but have been really satisfied overall. The installation is clear-cut and fast-- you turn off your phone, spray the liquid that's included on your fingertips and on the front and back of the screen protector, apply the adhesive side of the protector to your phone or device and slide it into position (making sure any holes/buttons are left uncovered), then use the included squeegee to smooth out any bubbles or wrinkles. You then leave the device turned off overnight while it dries and typically any remaining bubbles that resisted the squeegee will smooth themselves out by the morning. I like that the company provides video instructions to ensure that the protector is applied correctly the first time. Most newer phones are water resistant but even before with my older Android phone models, the small amount of liquid from the spray solution never damaged my phone which was something I was a little worried about at first. The touch screen works well with the screen protector on (and writing or drawing with the stylus is still smooth). I like that the protector sticks to the sides of the screen and stays down despite the curved edges of the Galaxy Note. One thing that I have found is that if you tend to take your phone case on and off a lot (or possibly even if you don't), the screen protector will eventually start peeling away from the phone on one side and will need to be replaced. Sometimes I've had the protectors last only a few months before needing a replacement but at other points the screen protector has lasted and been in good shape for over a year at a time. Since they are so inexpensive (especially compared to the really pricey ones I've seen at cell phone stores at the mall), I've never minded having to replace them periodically. I was really happy to see that this time two screen protectors came together in one pack so that I could replace mine once without even having to re-order. In the past I've used ArmorSuit's lifetime replacement program to order replacement protectors and have been happy with the customer service which was as promised-- they replaced the cover free of charge but I had to submit an order form and pay a few dollars for shipping. The best part about these screen protectors is that I've (so far) never had my screen crack when it's been dropped with the protector and a phone case on. My last phone was dropped and the screen cracked slightly in two places (before I had had a chance to put an ArmorSuit protector on it)-- I subsequently covered the cracked screen with an ArmorSuit screen protector and that prevented the cracks from EVER spreading over a period of several years until I upgraded to my new phone. I was really impressed since everything I read online said that the cracks in your screen will eventually start to expand no matter what you do! I'm convinced that it was the ArmorSuit screen protector that prevented the cracks from spreading and becoming more of a problem. I highly recommend this product and will continue using them for as long as they make screen protectors that fit my devices!

Thanks, easy to install just follow the instructions & I love it.

Not only does it fit perfectly, they are case friendly. They leave a tiny amount of material off the outside edge so cases that bite hard on their inner edge, don't affect the film. No fingerprints was why I bought, being case friendly was a bonus. 5 stars.

This may be a great product for non-curved devices. Just not this phone. I installed the film on the phone as instructed and with no problems but when the sides dried up they started lifting. I wrapped the phone in saran wrap to keep the sides in place overnight but as soon as I removed the wrap the sides lifted. I cannot be bothered with stuff that just do not work no matter how much hype companies create. I repacked everything and it's going back. My rating does not reflect the quality of the product for other applications, only mine. Two stars for quick and bubble-free installation. If you can make it work on this phone you're laughing!

Muy recomendable.

This is actually a great screen protector, I bought it quickly after buying my S8+ and although I am becoming a bit of an expert at fitting these things, having bought, and tried many in the last week or two - this one was a little tricky. Perhaps I used too much of the liquid they give you, but I couldn't get the protector to sit still on the screen when I was using the squeegy to get the liquid off.Anyway, eventually I figured it out, and the protector sat nicely, no smudges, bubbles or dust, and there was no loss of sensitivity when using the screen. It was also case friendly for my Spigen Tough Armour case, had no issues with the two being on the phone at the same time.I have to say that in the end I opted to go for a tempered glass cover for my phone, as I am just too clumsy and paranoid to risk it, but if I wanted a screen protector, this would be very high on the list