Metal Front & Rear Portal Axle Set Upgrades Parts Compatible with WPL C14 C24 C34 C44 B14 B24 1/16 RC Car (Black)

This is A kit. It's casted well but needs cleaning (matching,sanding) always fully disassemble all the parts you get. Shims and micro bolt kit you will want. When I removed the pumpkin covers I could see the inter bearings sliding around. (Matching)

The media could not be loaded. Pretty much the same design as everyone else, I wish they'd offer an open diff version for trail runners but for crawling they're fine, mine were well aligned as far as seams etc, however they had zero grease in them, I prefer what I use anyway. Still waiting on parts to complete the build but I have no regrets from what I've seen so far

Absolute garbage. Got them and put them in my truck and everything steering related was loose and couldent be tightened. And the front end, the gears stripped out after 2 rides and there is so much slack in them. Ended up buying some plastic cases portal axles and they are so much better.

Complete garbage don't buy and if you do buy take it completely apart and tighten and loctite every little screw on it otherwise it's going to fall apart over and over and after you take it apart once the screws strip so good luck

They work fine, look good. Arrived on time. Not the best quality. The seams where the two axle tube halves meet is not flush everywhere, especially on the ends. Axles are bone dry & need grease added, both the diffs & all the bearings. The adjustable steering links do not have locking nuts, so the rods constantly loosen themselves over time. The steering links also need adjusted immediately as the wheel hub alignment is wayyy off. The knuckles were also too tight making it difficult to turn.

They fit my Wpl c14 great!Makes sure to take apart grease them and thread lock the screws :)-any down fallsThey’re lightly greased soo make sure to grease them!They are heavy vs stock so metal driveshafts are a must!Low ground clearance I’ve hit differentials most and the steering linkage. But other than ground clearance I have had no issues yet! Rc on!

GARBAGE…. Worked for about 2 minutes and now the gears aren’t engaging so the tires won’t spin. Went to get a refund and Amazon demands that I send these back, the closest ups store is 35 minutes out of my way.

These would be better if I didn’t have to do so much to them. The finish on these axles are nice. However, there are several things that I would recommend doing before installing them.1) These axles come dry, so make sure you grease them.2) Put blue loctite on the small allen screws that hold the stubs on the rear axle. If you don’t, they will back out, making the wheels wobble and likely fall off.3) Put a nut on one end of the steering / alignment rod on the front axle. It does not come with one, and it’ll spin while driving it over stuff, causing your alignment to get all wonky.4) Metal driveshafts are a must as the stock plastic WPL ones do not fit without forcing them on. Even then, they do not go all the way on.Once all of this is done, they work great. They do seem to improve the steering radius of the truck a little. If I can do half stars it would be a 3.5.